![]() ![]()
The command to open the config.txt file via PuTTYĬheck if the screen is inverted and if so make the following changes to config.txt.Since my case mounts the screen upside down it wasn’t correct and I needed to rotate the screen 180 degrees. We haven’t installed anything yet but we want to make sure everything is wired right and that the orientation is correct. Technically this is a picture of my second boot since I’ve already flipped the screen in this image.The touchscreen is connected to the Pi in a few places.Ĥ) Boot the Pi with the Touchscreen and Confirm it is Working Shut down the Raspberry pi and disconnect it from the 3D printer. Repetier server touchscreen mode exit software#This case mounts the screen upside down which is better for my setup wiring but will require some software changes later.Mount the Pi on the back of the touch screen and connect the ribbon cable.Connect the dupont wires to the touchscreen.3) Disconnect Your Pi from the Printer and Connect it to the Touchscreen I may revisit this and make a mount for the Ender 3 later which will be linked here. Repetier server touchscreen mode exit install#For my install on my Ender 3 I decided that I was going to print the case for it and then mount it to the workbench next to the printer as opposed to directly on the printer. If you are printing instead of buying your touchscreen case then you should make sure this is done first and all the parts fit. It isn’t a bad idea to make a backup of your working Octoprint settings (you have confirmed it is working first right?) from within the settings menu and download them externally before continuing. A lot of the basic steps such as connecting to the Pi via SSH are covered in the Octoprint setup guide, so even if you already have a working Octoprint installation, give it a read. Make, save, and restore backups from this menu.įollow our guide to setting up a Raspberry Pi with Octoprint.Steps to Install Octodash for Octoprint 1) Install Octoprint on a Raspberry Pi ![]() ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |